Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Best Selling in Other Electrical Equipment & Supplies
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Save on Other Electrical Equipment & Supplies
This works but you need to give it a lot of time to dry, depending on the thickness its days to dry even a thin layer but if you accept this it actually works. I would not describe it as "glue" more like paint and its worth noting its not conductive until dry! For the price its worth a go, I had limited success repairing a track on a rotary switch worked for a little while till arcing destroyed the fix but to be fair I think I was pushing it as the current is about 3A across it which I dont think this product is suitable for. Minor small low current tracks should work ok but then you could just solder bridge them. For the price give it a go
Verified purchase: Yes | Condition: New
First time I've used this product. The paste wouldn't exit the hypodermic needle supplied. Increasing the pressure blew the needle off, spilling all the paste. The only text was in Chinese, so I have no idea whether or not I was using it correctly, if I had to heat it. Might be good if English instructions were included. Might be good quality, but I can't say, as I had to abandon it. Can't recommend it in its current form, without instructions.
Verified purchase: Yes | Condition: New
My assessment is based holy on what I needed the product for which wasn't delicate soldering on PCBs. So, I wouldn't recommend it because the amount of 'solder' provided is I would say minimal. The hypodermic containing the solder could hold a deal more. I bought three tubes for my task but that wasn't sufficient.....I'm now wondering if there's any other option for me as using 'hot' solder would damage the thin sheet aluminium I'm working with. I also found that to get the solder to set/harden I had to judiciously use a hot air gun....no problem but an unexpected neccessity. I've rated it 'no' for quality only because it didn't work for me. I've not compared it to other similar products. All in all, I was disappointed with the product, despite reading all the information provided online.
Verified purchase: Yes | Condition: New
Suitable for repairing PCB tracks and pads; its best to use a very small amount to ensure it sets. Not suitable for connecting wires to PCB Requires moderate heat to cure.
Verified purchase: Yes | Condition: New
Much to my surprise this fixed a loose connection on a heated rear window. The semi-rigid feed wire wanted to pull off the connection and this product would not hold but a temporary piece of tape did the trick until the adhesive had set. Good fix and good connection: clear window.
Verified purchase: Yes | Condition: New